P Pro HVAC
Medina, OH · 44256 Ohio · 24/7 line

Furnace Ignition and Pilot Light Repair in Medina, OH Near Me

Pilot light going out or furnace clicking without lighting in Medina, OH? Pro HVAC connects you with an HVAC professional. Call (321) 463-9811.

Ohio Statewide
Symptom-First Matching
24/7 Emergencies
No Obligation

A furnace that clicks, hums, then falls silent without heat is failing somewhere in its ignition sequence. On newer systems the usual culprits are a cracked or worn hot surface ignitor, a flame sensor coated in oxide so it cannot prove flame, or a pressure switch that will not close because the flue or condensate line is blocked. On older standing-pilot units, a pilot that lights but will not stay lit usually points to a failing thermocouple or a draft reaching the pilot assembly.

These faults follow a diagnosable order and a professional will work through it rather than replacing parts on guesswork. Repeated ignition lockouts should not be reset over and over, since each attempt puts unburned gas into the chamber. Pro HVAC connects homeowners in Medina, OH with HVAC professionals. Call (321) 463-9811.

How it works

Four simple steps to Furnace Repair in Medina, OH

01

Tell us the symptom

Tell us what your system is doing in Medina, OH.

02

Matched to the fault

We match the symptom to a professional who handles that fault.

03

They contact you

They contact you directly to arrange the visit.

04

If it is not right

If they cannot help, tell us and we find another.

Coverage

Furnace Repair Services Across Medina, OH

Covering Medina, OH and nearby ZIPs across Ohio.

Neighborhoods we cover for Furnace Repair

  • Downtown Medina
  • The Highlands
  • North Court Village

ZIP codes we serve

44256
Furnace Ignition And Pilot Light Repair in Medina, OH

Furnace Ignition And Pilot Light Repair FAQs

Frequently asked questions about Furnace Ignition and Pilot Light Repair

Questions we hear most often about Furnace Ignition and Pilot Light Repair in Medina, OH.

Talk to a real person
Why is my furnace blowing cold air instead of heat?
A dirty air filter restricts airflow and often causes a furnace to blow cold air. Turn the system off, replace the filter with the correct size, and wait 30 minutes before restarting. Check that the thermostat is set to heat mode and the temperature is higher than room temperature. In Medina, OH winters, a clogged filter can lead to frozen coils if ignored. If the problem continues after the filter change, the issue may involve the blower motor or limit switch.
Why won't my thermostat turn the furnace on?
Thermostat won't turn the furnace on? Here is what is usually behind it. Blank screen: swap the batteries. If it stays dark, the thermostat has probably lost its 24-volt supply, often from a blown low-voltage fuse on the furnace control board. Screen lit, no heat: confirm it is set to heat and no schedule or hold is overriding it. Make sure the furnace door is seated, since its safety switch cuts power when loose. Look for a tripped condensate float switch too. Stop and get a professional if a replacement fuse blows again. That fuse is a symptom of a short in the thermostat wiring, not a part to keep swapping. If you smell burning or see scorched wire, shut the furnace off at the breaker now. Pre-1990 Medina, OH homes often lack a common wire, which is why many smart thermostat installs fail. Pro HVAC is a referral service connecting Ohio homeowners with local HVAC pros. Call (321) 463-9811.
What should I do when there is no heat overnight in Medina, OH winter?
Check the thermostat batteries and confirm the switch is set to heat. Replace the furnace filter if it is dirty, then verify the breaker is on. If the furnace still does not respond, turn the system off at the breaker to prevent further damage. Call (321) 463-9811 for referral to a local technician who can diagnose the issue safely.
Do I need an AC recharge, or do I have a refrigerant leak?
A sealed air conditioning system does not use refrigerant up, so if the charge is low there is a leak somewhere. Cooling that weakens season after season, ice on the line set, or a hissing sound near the indoor unit all point to a leak rather than normal top-up. Adding refrigerant without locating the leak means paying again next season, and running low charge makes the compressor run hot. Ask for the leak to be found and quoted before agreeing to a recharge in Medina, OH.
Can a dirty air filter really break my heating or cooling system?
Yes, and it is the most common cause of faults that look like equipment failure. A restricted filter makes a furnace overheat and shut down on its limit switch, freezes an air conditioning evaporator coil solid, and makes the blower motor draw high current until it fails early. Two things matter more than brand: the filter must fit its slot tightly, because a loose filter lets air bypass it completely, and a very high MERV rating in a system not designed for it restricts airflow enough to cause the same overheating it was meant to prevent. A filter that darkens within weeks in Medina, OH usually means duct leakage is pulling in unfiltered air.

Talk to an Ohio HVAC repair

Need Furnace Repair in Medina, OH? Call now.

Describe the symptom and we connect you with an Ohio HVAC repair pro for Furnace Repair or Emergency HVAC Repair. Call (321) 463-9811.

Call (321) 463-9811 Services